Cut-out Handles

5 minutes
Squeegee (included)
Step 1

ALIGN SHEET

Align the sheet over the surface you are going to wrap.

Step 2

REMOVE BACKING STRIP #1

The backing sheet is cut into numbered sections.

While holding the sheet face down with one hand, reach underneath with your other hand and peel the backing strip labeled "1".

Step 3

REMOVE ADDITIONAL BACKING STRIPS ALONG CUTOUT EDGE

Repeat Step 2 for the smaller backing strips along the edge where the cutout is located. Start with the strip labeled "2"

Remove remaining backing strips in the order of the numbered labels

 

Step 4

REMOVE FINAL SECTION OF BACKING

Fold the sheet over and grasp the final section of the backing. Peel back slowly with both hands. Once the backing has been removed, the PANYL should cover the surface evenly.

Step 5

SMOOTH SURFACE WITH SQUEEGEE

Use your squeegee to apply pressure to surface. Start in the center, moving the squeegee from top to bottom. Then move from the center to the sides, alternating from left to right.